USB2.0 一致性測試介紹
加入技術交流群
2.5GHz帶寬、40GS/s采樣率、最大256Mpts的可分析存儲深度，X-StreamII流式結構——速度快于其它示波器10-100倍，具備最深的測量參數工具箱、函數運算工具箱，獨特的TriggerScan異常捕獲技術使得示波器能在單位時間內捕獲更多的異常優越的瞬時響應能力，15.3英寸寬屏WXGA彩色觸摸屏顯示器。
二、測試夾具：
TF-USB-B（一致性測試板，能夠完成USB2.0的一致性測試功能；負載板能夠完成Droop電壓和Drop電壓相關測試）
三、測試軟件：
QualiPHY測試軟件的USB測試模板，能夠完成低速率Device、全速率和高速率Host、Device、Hub的USB一致性測試，支持全部USB-IF組織制定的一致性測試規范。
四、測試項目列表
| 測試項目 | 測試指標 | 標準值 | 對應標準號 | 參考標準 |
| Signal Rate 信號速率測量結果 | Signal Rate 信號速率 | 479.76Mb/s≤x≤480.24Mb/s | 7.1.11 Data Signaling Rate | Universal Serial Bus Specification Revision 2.0 |
| Eye Result 眼圖模板測量結果 | Eye Violations 眼圖電壓 | x=0 | 7.1.2.2 High-speed Signaling Eye Patterns and Rise and Fall Time 7.1.3 Cable Skew | |
| Consecutive Jitter Min 最小連續抖動 | x≤100ps | |||
| Consecutive Jitter Max 最大連續抖動 | x≤100ps | |||
| Consecutive RMS Jitter RMS連續抖動 | x≤100ps | |||
| Paired JK Jitter Min JK配對最小抖動 | x≤100ps | |||
| Paired JK Jitter Max JK配對最大抖動 | x≤100ps | |||
| Paired JK RMS Jitter JK配對RMS抖動 | x≤100ps | |||
| Paired KJ Jitter Min KJ配對最小抖動 | x≤100ps | |||
| Paired KJ Jitter Max KJ配對最大抖動 | x≤100ps | |||
| Paired KJ RMS Jitter KJ配對RMS抖動 | x≤100ps | |||
| Rising Edge Rate Result 邊沿上升時間和速率測量結果 | Rising Edge Rate Min 邊沿上升最小速率 | x≤1600MV/s | 7.1.2.2 High-speed Signaling Eye Patterns and Rise and Fall Time | Universal Serial Bus Specification Revision 2.0 |
| Rise Time Max (equivalent) 最大上升時間 | x≥500ps | |||
| Rising Edge Rate Max 邊沿上升最大速率 | x≤1600MV/s | |||
| Rise Time Min (equivalent) 最小上升時間 | x≥500ps | |||
| Rising Edge Rate Mean 邊沿上升速率測量值 | x≤1600MV/s | |||
| Rise Time Mean (equivalent) 上升時間測量值 | x≥500ps | |||
| Falling Edge Rate Result 邊沿下降時間和速率測量結果 | Falling Edge Rate Min 邊沿下降最小速率 | x≤1600MV/s | 7.1.2.2 High-speed Signaling Eye Patterns and Rise and Fall Time | Universal Serial Bus Specification Revision 2.0 |
| Fall Time Max (equivalent) 最大下降時間 | x≥500ps | |||
| Falling Edge Rate Max 邊沿下降最大速率 | x≤1600MV/s | |||
| Fall Time Min (equivalent) 最小下降時間 | x≥500ps | |||
| Falling Edge Rate Mean 邊沿下降速率測量值 | x≤1600MV/s | |||
| Fall Time Mean (equivalent) 下降時間測量值 | x≥500ps | |||
| Edge Rate Match 邊緣速率匹配 | 符合模板要求 | |||
| Edge Monotonicity Result 邊沿單調測量結果 | Edge Monotonicity Result 邊沿單調測量結果 | 符合模板要求 | 7.1.2.2 High-speed Signaling Eye Patterns and Rise and Fall Time | Universal Serial Bus Specification Revision 2.0 |
| EOP Width Result 結束包位寬測量結果 | EOP Width 結束包位寬 | 7.5bits≤x≤8.5bits | 7.1.13.2.2 High-speed EOP | |
| Device Chirp K Latency 驅動周糾K碼延遲時間 | 2.50μs≤x≤7.00ms | 7.1.7.5 Reset Signaling | ||
| Chirp K Duration 周糾K碼周期時間 | 1.00ms≤x≤7.00ms | |||
| HS Turn On Time After Chirp 周糾后高速率開啟時間 | x≤500.0μs | |||
| Suspend Timing 暫停時間 | 3.000ms≤x≤3.125ms | 7.1.7.6 Suspending | ||
| Suspend D- Volts D-暫停電壓 | x≤700.0mV | |||
| Suspend D+ Volts D+暫停電壓 | 2.70V≤x≤3.60V | |||
| HS SOF After Resume 暫停后恢復到高速SOF | 符合模板要求 | 7.1.7.7 Resume | Universal Serial Bus Specification Revision 2.0 | |
| Resume Amplitude D- D-恢復幅值 | x≤700mV | |||
| Resume Amplitude D+ D+恢復幅值 | x≤700mV | |||
| Reset Time 復位時間 | 3.10ms≤x≤6.00ms | 7.1.7.5 Reset Signaling | ||
| Suspend to Reset Time 暫停后復位時間 | 2.5μs≤x≤6.0000ms | |||
| J Voltage D+ D+ J電壓 | 360.0mV≤x≤440.0mV | 7.1.1.3 High-speed (480 Mb/s) Driver Characteristics | ||
| J Voltage D- D- J電壓 | -10.0mV≤x≤10.0mV | |||
| K Voltage D+ D+ K電壓 | -10.0mV≤x≤10.0mV | |||
| K Voltage D- D- K電壓 | 360.0mV≤x≤440.0mV | |||
| SE0 D- Voltage D- SEO電壓 | -10.0mV≤x≤10.0mV | |||
| SE0 D+ Voltage D+ SEO電壓 | -10.0mV≤x≤10.0mV | |||
| VBUS Voltage Before Enumeration 列舉前的電源線VBUS反饋電壓值 | x≤400mV | 無 | 無 | |
| D+ Voltage Before Enumeration 列舉前的數據線D+反饋電壓值 | x≤400mV | 無 | ||
| D- Voltage Before Enumeration 列舉前的數據線D-反饋電壓值 | x≤400mV | 無 | ||
| VBUS Voltage After Enumeration 列舉后的電源線VBUS反饋電壓值 | x≤400mV | 無 | ||
| D+ Voltage After Enumeration 列舉后的數據線D+反饋電壓值 | x≤400mV | 無 | ||
| D- Voltage After Enumeration 列舉后的數據線D-反饋電壓值 | x≤400mV | 無 | ||
評論